Dell S4810 - Page 1648

end-month Enter the name of one of the 12 months in English.
end-time Enter the time in hours:minutes:seconds. For the hour
variable, use the 24-hour format; example, 17:15:00 is 5:15
pm.
offset (OPTIONAL) Enter the number of minutes to add during the
summer-time period. The range is from 1 to 1440. The
default is 60 minutes.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Updated the start-day and end-day options to allow for
using the three-letter abbreviation of the weekday name.
pre-Version
6.1.1.0
Introduced on the E-Series.
Related
Commands
calendar set — sets the hardware clock.
clock summer-time date — sets a date (and time zone) on which to convert the
switch to daylight saving time on a one-time basis.
show clock — displays the current clock settings.
1648
System Time and Date