Dell S4810 - Page 1707

the limit is reached, additional dynamic routes will not be
allowed.
warning-only When the warning-only option is used, a syslog message will
be thrown when maximum number of dynamic routes
reaches the limit. Additional dynamic routes will still allowed.
Defaults No limit is set on the maximum number of dynamic routes for a VRF.
Command
Modes
CONFIGURATION-VRF
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OSCommand Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4(0.0) Introduced on the S–Series.
Usage
Information
If the maximum route limit is not specified for a VRF, then it has unlimited space
that extends to the maximum number of entries allowed for the system. This
command is not applicable to the default and management VRFs.
show ip vrf
Displays information corresponding to the VRFs that are configured in the system.
S4810
Syntax
show ip [vrf vrf-name]
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to
display information corresponding to that VRF..
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Introduced on the S-Series and Z-Series.
Version 8.2.1.0 Introduced on the E-Series.
Example
show ip vrf
VRF-Name VRF-ID Interfaces
Virtual Routing and Forwarding (VRF)
1707