Dell S4810 - Page 1750

200.200.200.207 ... short desc
Gi 10/37 254 254 Y Master 200.200.200.200 200.200.200.204
200.200.200.205
Dell>
Usage
Information
The following describes the show vrrp command shown in the following
example.
Item Description
GigabitEthernet
12/3...
Displays the Interface, the VRRP group ID, and the network
address. If the interface is not sending VRRP packets, 0.0.0.0
appears as the network address.
State: master... Displays the interface’s state:
• Na/If (not available)
• master (MASTER virtual router)
• backup (BACKUP virtual router)
the interface’s priority and the IP address of the MASTER.
Hold Down:... This line displays additional VRRP configuration information:
• Hold Down displays the hold down timer interval in
seconds.
• Preempt displays TRUE if preempt is configured and
FALSE if preempt is not configured.
• AdvInt displays the Advertise Interval in seconds.
Adv rcvd:... This line displays counters for the following:
• Adv rcvd displays the number of VRRP advertisements
received on the interface.
• Adv sent displays the number of VRRP advertisements
sent on the interface.
• Gratuitous ARP sent displays the number of gratuitous
ARPs sent.
Virtual MAC
address
Displays the virtual MAC address of the VRRP group.
Virtual IP address Displays the virtual IP address of the VRRP router to which
the interface is connected.
Authentication:... States whether authentication is configured for the VRRP
group. If it is, the authentication type and the password are
listed.
Tracking states.. This line is displayed if the track command is configured
on an interface. Below this line, the following information
on the tracked interface is displayed:
• Dn or Up states whether the interface is down or up.
1750
Virtual Router Redundancy Protocol (VRRP)