Dell S4810 - Page 1759

Usage
Information
The following describes the show vrrp ipv6 command shown in the following
example.
Line Beginning
with
Description
GigabitEthernet... Displays the Interface, the VRRP group ID, and the network
address. If the interface is no sending VRRP packets, 0.0.0.0
appears as the network address.
VRF VRF instance to which the interface (on which the VRRP
group is configured) belongs.
State: master... Displays the interface’s state:
• Na/If (not available).
• master (MASTER virtual router).
• backup (BACKUP virtual router).
the interface’s priority and the IP address of the MASTER.
Hold Down:... This line displays additional VRRP configuration information:
• Hold Down displays the hold down timer interval in
seconds.
• Preempt displays TRUE if preempt is configured and
FALSE if preempt is not configured.
• AdvInt displays the Advertise Interval in seconds.
Adv rcvd:... This line displays counters for the following:
• Adv rcvd displays the number of VRRP advertisements
received on the interface.
• Adv sent displays the number of VRRP advertisements
sent on the interface.
• Bad pkts rcvd displays the number of invalid packets
received on the interface.
Virtual MAC
address
Displays the virtual MAC address of the VRRP group.
Virtual IP address Displays the virtual IP address of the VRRP router to which
the interface is connected.
Tracking states... Displays information on the tracked interfaces or objects
configured for a VRRP group (track command), including:
• UP or DOWN state of the tracked interface or object (Up
or Dn).
• Interface type and slot/port or object number,
description, and time since the last change in the state of
the tracked object.
Virtual Router Redundancy Protocol (VRRP)
1759