Dell S4810 - Page 472

received-
routes
[network
[network-mask]
(OPTIONAL) Enter the keywords received-routes then
either the network address (in dotted decimal format) or the
network mask (in slash prefix format) to view all information
received from neighbors.
NOTE: Configure the neighbor soft-
reconfiguration inbound
command prior to
viewing all the information received from the neighbors.
denied-routes
[network
[network-mask]
(OPTIONAL) Enter the keywords denied-routes then
either the network address (in dotted decimal format) or the
network mask (in slash prefix format) to view all information
on routes denied via neighbor inbound filters.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Added support for VRF.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.8.0 Added the add-path option to the S4810. Output on the
S4810 shows the ADDPATH parameters.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.5.1.0 Added the detail option. Output now displays the default
MED value.
Version 7.2.1.0 Added the received and denied route options.
Version 6.3.10 The output is changed to display the total number of
advertised prefixes.
Usage
Information
After a peer reset, the contents of the notification log messages is displayed in hex
values for debugging.
The neighbor information that this command displays does not include counts
corresponding to ignored prefixes and updates. However, the martian case is an
472
Border Gateway Protocol