Dell S4810 - Page 477

NOTE: Enter an escape sequence (CTRL+v) prior to
entering the ? regular expression.
• [ ] = (brackets) a range of single-character patterns.
• ( ) = (parenthesis) groups a series of pattern elements
to a single element.
• { } = (braces) minimum and the maximum match count.
• ^ = (caret) the beginning of the input string. If you use
the caret at the beginning of a sequence or range, it
matches on everything BUT the characters specified.
• $ = (dollar sign) the end of the output string.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4(0.0) Added support for VRF for the S4810, S4820T, and S6000.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
The following describes the show ip bgp path command shown in the
following example.
Field Description
Total Displays the total number of BGP path attributes.
Address Displays the internal address where the path attribute is
stored.
Hash Displays the hash bucket where the path attribute is stored.
Refcount Displays the number of BGP routes using this path attribute.
Metric Displays the MED attribute for this path attribute.
Path Displays the AS path for the route, with the origin code for
the route listed last. Numbers listed between braces {} are
AS_SET information.
Border Gateway Protocol
477