Dell S4810 - Page 502

validation for DHCP, Ethernet Connectivity Fault Management (CFM) ACLs, OpenFlow, and Policy-based
Routing (PBR).
S4810
Syntax
cam-acl {default | l2acl number ipv4acl number ipv6acl number
ipv4qos number l2qos number l2pt number ipmacacl number [vman-
qos | vman-dual-qos number] ecfmacl number ipv4pbr
number }openflow number | fcoe number} [iscsioptacl number]
[vrfv4acl number]
Parameters
default Use the default CAM profile settings and set the CAM as
follows:
• L2Acl : 6
• IPV4Acl : 4
• IPV6Acl : 0
• IPV4Qos : 2
• L2Qos : 1
• L2PT : 0
• IpMacAcl : 0
• VmanQos : 0
• VmanDualQos : 0
• EcfmAcl : 0
• FcoeAcl : 0
• iscsiOptAcl : 0
• ipv4pbr : 0
• vrfv4Acl :0
• Openflow : 0
• fedgovacl : 0
l2acl number Enter the keyword l2acl and then the number of l2acl
blocks. The range is from 1 to 8.
ipv4acl number Enter the keyword ipv4acl and then the number of FP
blocks for IPv4. The range is from 0 to 8.
ipv6acl number Enter the keyword ipv6acl and then the number of FP
blocks for IPv6. The range is from 0 to 4.
ipv4qos
number
Enter the keyword ipv4qos and then the number of FP
blocks for IPv4. The range is from 0 to 8.
l2qos number Enter the keyword l2qos and then the number of FP blocks
for l2 qos. The range is from 1to 8.
l2pt number Enter the keyword l2pt and then the number of FP blocks
for l2 protocol tunnelling. The range is from 0 to 1.
Ipmacacl
number
Enter the keyword ipmacacl and then the number of FP
blocks for IP and MAC ACL. The range is from 0 to 6.
502
Content Addressable Memory (CAM)