Dell S4810 - Page 882

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Added support for VRF and added usage information for the
clear arp-cache command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Added support for 4094 VLANs on the E-Series ExaScale (the
prior limit was 2094).
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.9.1.0 Introduced VRF on the E-Series.
Version 7.8.1.0 Augmented to display local ARP entries learned from private
VLANs (PVLANs).
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
The following example shows two VLANs that are associated with a private VLAN
(PVLAN) (refer to Private VLAN (PVLAN)).
If you have entered the clear arp-cache command to remove a large number
of ARP entries and the command is still being processed in the background, an
error message display if you attempt to enter the show arp command:
Clear arp in-progress. Please try after sometime!
The following describes the show arp command shown in the following example.
Description
Protocol Displays the protocol type.
Address Displays the IP address of the ARP entry.
Age(min) Displays the age (in minutes) of the ARP entry.
Hardware Address Displays the MAC address associated with the ARP entry.
Interface Displays the first two letters of the interfaces type and the
slot/port associated with the ARP entry.
882
IPv4 Routing