Dell S4810 - Page 899

Example
Dell#show ip int te 0/0
TenGigabitEthernet 0/0 is down, line protocol is down
Internet address is not set
IP MTU is 1500 bytes
Inbound access list is not set
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent
Dell#
Usage
Information
The following describes the show ip interface brief command shown in the
following example.
Fields Description
Interface Displays type of interface and the associated slot and port
number.
IP-Address Displays the IP address for the interface, if configured.
Ok? Indicates if the hardware is functioning properly.
Method Displays “Manual” if the configuration is read from the saved
configuration.
Status States whether the interface is enabled (up) or disabled
(administratively down).
Protocol States whether IP is enabled (up) or disabled (down) on the
interface.
Example (Brief)
Dell#show ip int brief
Interface IP-Address OK? Method
Status Protocol
GigabitEthernet 1/0 unassigned NO Manual administratively
down down
GigabitEthernet 1/1 unassigned NO Manual administratively
down down
GigabitEthernet 1/2 unassigned YES Manual
up up
GigabitEthernet 1/3 unassigned YES Manual
up up
GigabitEthernet 1/4 unassigned YES Manual
up up
GigabitEthernet 1/5 10.10.10.1 YES Manual
up up
GigabitEthernet 1/6 unassigned NO Manual administratively
down down
IPv4 Routing
899