Dell S4810 - Page 943

tunnel tunnel-
id
(OPTIONAL) View information for a tunnel interface.
vlan (OPTIONAL) View information for IPv6 VLANs.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2.
(0.0)
Added support for tunnel interface.
Version 9.0.0.0 Introduced on the Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.4.2.1 Introduced on the S-Series.
Version 8.2.1.0 Introduced on the E-Series ExaScale. Added support for the
managementethernet slot/port parameter.
Version 7.8.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
The Management port is enabled by default (no shutdown). If necessary, use the
ipv6 address command to assign an IPv6 address to the Management port.
Example
Dell#
Dell#show ipv6 int te 0/5
TenGigabitEthernet 0/5 is up, line protocol is up
IPV6 is enabled
Link Local address: fe80::201:e8ff:fe8a:e8f7
Global Unicast address(es):
2001::1, subnet is 2001::/64
2002::1, subnet is 2002::/120
2003::1, subnet is 2003::/120
2004::1, subnet is 2004::/32
Global Anycast address(es):
Joined Group address(es):
ff02::1
ff02::2
ff02::1:ff00:1
ff02::1:ff8a:e8f7
ND MTU is 0
ICMP redirects are not sent
DAD is enabled, number of DAD attempts: 3
ND reachable time is 0 milliseconds
IPv6 Basics
943