User Manual UMN:CLI
V5808
103
To delete all collected statistics for an Ethernet port, use the following command.
clear port statistics {PORTS | all}
Deletes all collected statistics for an Ethernet port.
PORTS: port number
5.1.10.2 CPU Statistics
To display the statistics of the traffic handled by CPU, use the following command.
show cpu statistics avg-pkt
[PORTS]
Shows the statistics of the traffic handled by CPU per
packet type.
show cpu statistics total
[PORTS]
Shows the traffic statistics of the average packet
handled by CPU.
To delete the collected statistics of the traffic handled by CPU, use the following
command.
clear cpu statistics [PORTS]
Deletes the collected statistics of the traffic handled by
CPU.
The V5808 can be configured to generate a syslog message when the number of the
packets handled by CPU exceeds a specified value. This function allows system
administrators to monitor the switch and network status more effectively.
To configure the switch to generate a syslog message according to the number of the
packets handled by CPU, use the following command.
cpu statistics-limit {unicast |
multicast | broadcast} PORTS
<10-100>
Generates a syslog message according to the
specified number of the packets handled by CPU. This
is configurable for each packet type and physical port.
unicast | multicast | broadcast: packet type
PORTS: port number
10-100: packet count (actual value: 1000-10000)
To disable the switch to generate a syslog message according to the number of the
packets handled by CPU, use the following command.
no cpu statistics-limit {unicast |
multicast | broadcast} {PORTS |
all}
Disables the switch to generate a syslog message
according to the number of the packets handled by
CPU for each packet type.
all: all physical ports
To Next Page
Loading...