UMN:CLI User Manual
V5808
554
no area {<0-4294967295> | A.B.C.D} nssa no-summary
translator-role no-redistribution
no area {<0-4294967295> | A.B.C.D} nssa translator-role
[default-information-originate]
no area {<0-4294967295> | A.B.C.D} nssa translator-role
default-information-originate [no-redistribution] [no-
summary]
no area {<0-4294967295> | A.B.C.D} nssa translator-role no-
redistribution [default-information-originate] [no-summary]
no area {<0-4294967295> | A.B.C.D} nssa translator-role no-
summary [no-redistribution] [default-information-originate]
11.2.6.5 Area Range
In case of OSPF belongs to several Areas, Area routing information can be shown in one
routing path. Like as above, various routing information of Area can be combined and
summarized to transmit to outside.
To summarize and combine the routing information, use the following command.
area {<0-4294967295> | A.B.C.D} range
A.B.C.D/M
Configures to use summarized
information for assigned path.
area {<0-4294967295> | A.B.C.D} range
A.B.C.D/M {advertise | not-advertise}
Use advertise option to transmit summarized routing information with using summarized
information. And use the not-advertise option to block the transmission of summarized
routing information to outside.
To release the configuration, use the following command.
no area {<0-4294967295> | A.B.C.D} range
A.B.C.D/M
Releases the configuration to use
summarized information for
assigned path
no area {<0-4294967295> | A.B.C.D} range
A.B.C.D/M {advertise | not-advertise}
11.2.6.6 Shortcut Area
Backbone Area is the default Area among the Areas of OSPF. All traffic should pass the
Backbone Area and OSPF network must be planned for that, but there is some efficiency
way which is not to pass the Backbone Area. That is Shortcut, and it must be configured
for efficient traffic in every ABR type, see Section 11.2.2.
To configure the shortcut option, use the following command.
area {<0-4294967295> | A.B.C.D}
Configures the shortcut option.
To Next Page
Loading...