Dasan V5808 - Restarting RIP; UDP Buffer Size of RIP; Monitoring and Managing RIP

User Manual UMN:CLI
V5808
599
must share the MD5 key to decrypt the message and
encrypt the response.
ip rip authentication string
STRING
Interface
Configures RIP authentication string which will be
using on interface without Key chain. The string must
be shorter than 16 characters.
STRING: RIP authentication string
To disable RIP authentication, use the following command.
Command
Mode
Description
no ip rip authentication key-
chain NAME
Interface
Disables authentication keys that can be used on an
interface.
no ip rip authentication mode
{text | md5}
Disables specified authentication mode.
no ip rip authentication string
STRING
Removes RIP authentication string which will be using
on interface without Key chain.
11.4.14 Restarting RIP
Occasionally, you should restart RIP system only when the switch is still operating while
you manage and configure RIP. At this time, the switch reports the neighbors that RIP
system is being restarting. It keeps previous route information until the restarting is
complete in timer.
To restart RIP system only, use the following command.
Command
Mode
Description
rip restart grace-period
<1-65535>
Global
Restarts RIP system and set the period.
no rip restart grace-period
[<1-65535>]
Removes a configured period.
11.4.15 UDP Buffer Size of RIP
RIP protocol exchanges the routing information between routers using UDP packets. The
V5808 can be configured theses UDP packets buffer size, use the following command.
Command
Mode
Description
recv-buffer size <8196-
2147483647>
Router
Sets the UDP Buffer size value for using RIP.
8196-2147483647: UDP buffer size value
no recv-buffer size <8196-
2147483647>
Restore the default value of UDP buffer size.
11.4.16 Monitoring and Managing RIP
You can display specific router information such as the contents of IP routing tables, and