UMN:CLI User Manual
V5808
120
no threshold module {rxpower |
voltage | txbias | txpower |
temper} {alarm | warning}
PORTS
Deletes the configured threshold of SFP module and
restores the current threshold to a default value.
To display the configuration of SFP module of specific port, use the following command.
show port module-info [PORTS]
Shows the information of SFP module (including
threshold configuration).
6.1.14 Enabling DMI Module
If you insert an SFP module including Diagnostic Monitoring Interface (DMI) into ports,
you can see the real-time information about the ports such as transceiver type, length,
connector type, and vendor information of the SFP. However, you might not want to see
DMI polling information because it may result in CPU overload to collect DMI data via I
2
C
interface. To enable or disable collecting DMI information from SFP mouldes, use the
following command.
module dmi {enable | disable}
Specifies whether to collect DMI information from
SFP modules.
This module DMI command is enabled by default. Thus, if you don’t want to get DMI
information, configure this setting as disable.
If disabled, the V5808 does not show DMI information of the SFP ports when using the
show port module-info command.
To display the configuration of DMI module, use the following command.
Displays the configuration result of DMI module.
To display the DMI-related information, use the following command.
show port module-info [PORTS]
Shows the information of SFP module (including
threshold configuration).
To Next Page