User Manual UMN:CLI
V5808
215
To disable the configuration of port secure, use the following command.
Disables port security on the port.
no port security PORTS mac-
address [MAC-ADDR vlan NAME]
Deletes a secure MAC address for the port.
no port security PORTS
maximum
Returns to the default number of secure MAC
addresses. (default: 1)
no port security PORTS
violation
Returns to the violation mode to the default.
(default: shutdown)
To reset the configuration of secure MAC address, use the following command.
clear port security PORTS mac-
address [MAC-ADDR vlan NAME]
Deletes the configuration of secure MAC address on
specified port.
7.10.2 Port Security Aging
Port security aging is to set the aging time for all secure addresses on a port. Use this
feature to remove and add PCs on a secure port without manually deleting the existing
secure MAC addresses while still limiting the number of secure addresses on a port.
port security PORTS aging
static
Enables aging for configured secure addresses.
port security PORTS aging time
<1-1440>
Configures aging time in minutes for the port. All the
secure addresses age out exactly after the time.
port security PORTS aging type
{absolute | inactivity}
• absolute all the secure addresses on this port age out exactly after the time (min-
utes) specified lapses and are removed from the secure address list.
• inactivity the secure addresses on this port age out only if there is no data traffic
from the secure source addresses for the specified time period.
To disable the configuration of port secure aging, use the following command.
no port security PORTS aging
static
Disables aging for only statistically configured secure
addresses.
no port security PORTS aging
time
Disables port secure aging for all secure addresses on
a port.
no port security PORTS aging
type
Returns to the default condition. (absolute)
To Next Page
Loading...