Dasan V5808 - Network Service Module (NSM) Daemon Debugging; To Disable NSM Debugging; To Display the Debugging Information; To Disable All Debugging

User Manual UMN:CLI
V5808
139
show boot-info
Enable
Global
Bridge
Shows the information of the last system boot.
6.3.18 Network Service Module (NSM) Daemon Debugging
To enable NSM daemon debugging, use the following command.
Command
Mode
Description
debug nsm [all]
Enable
Enables NSM debugging.
all: all NSM debugging
debug nsm {events | kernel}
Enables NSM events/kernel debugging.
debug nsm packet {send | recv}
[detail]
Enables NSM packets debugging.
packet: NSM packets
send: outgoing packets
recv: incoming packets
detail: detailed information
debug nsm packet [detail]
To disable NSM debugging, use the following command.
Command
Mode
Description
no debug nsm [all]
Enable
Disables NSM debugging.
no debug nsm {events | kernel}
no debug nsm packet {send | recv} [detail]
no debug nsm packet [detail]
To display the debugging information, use the following command.
Command
Mode
Description
show debugging nsm
Enable
Global
Bridge
Shows the debugging information of NSM.
To disable all debugging, use the following command.
Command
Mode
Description
no debug all [ipv6 | nsm | ospf |
rip]
Enable
Disables all debugging.