Dasan V5808 - Overview of Configuration Mode

User Manual UMN:CLI
V5808
49
3.2 Configuration Mode Overview
Fig. 3.1 shows the overview of the configuration mode for the V5808.
Privileged EXEC View
SWITCH>
Privileged EXEC Enable
SWITCH#
Global Configuration mode
SWITCH(config)#
Bridge Configuration mode
SWITCH(bridge)#
Interface Configuration mode
SWITCH(config-if)#
RMON Configuration mode
SWITCH(config-rmonalarm[N])#
SWITCH(config-rmonevent[N])#
SWITCH(config-rmonhistory[N])#
DHCP Pool Configuration mode
SWITCH(config-dhcp[POOL])#
enable
configure terminal
bridge
interface INTERFACE
INTERFACE: interface name
ip dhcp pool POOL
(POOL: pool name)
rmon-alarm <1-65535>
rmon-event <1-65535>
rmon-history <1-65535>
exit
Back to previous mode
Route-map Configuration mode
SWITCH(config-route-map)#
router {IP-PROTOCOL | vrrp}
IP-PROTOCOL: protocol name
Router Configuration mode
SWITCH(config-dhcp[POOL])#
route-map NAME
{permit | deny} <1-65535>
Option 82 Configuration mode
SWITCH(config-opt82)#
ip dhcp option82
GPON Configuration mode
SWITCH(gpon)#
gpon
ONU Profile Configuration mode
SWITCH(config-onu-profile[NAME])#
gpon-olt OLT-ID
GPON-OLT Configuration mode
SWITCH(config-gpon-olt[N/N])#
onu-profile NAME create
NAME: ONU profile name
Rule Configuration mode
SWITCH(config-flow[NAME])#
SWITCH(config-policer[NAME])#
SWITCH(config-policy[NAME])#
flow [admin] NAME create (NAME: flow name)
policer NAME create (NAME: policer name)
policy [admin] NAME create (NAME: policy name)
Fig. 3.1 Overview of Configuration Mode