User Manual UMN:CLI
V5808
615
information between the CE and the PE.
The OSPF process sends the routing information that was advertised into the NSM. This
is sent to the NSM server by the NSM-Protocol messaging protocol. Because the NSM
message that is sent to the NSM server includes VRF-ID value, the routing information
that is sent from the dynamic routing protocol to the NSM daemon makes an appropriate
VRF routing table updated.
To specify the existing VRF instance in running OSPF, use the following command.
Specifies the VRF instance in running OSPF/OSPFv3
process. A specified OSPF/OSPFv3 process
implements routing with the interfaces connected to
this VRF.
WORD: 1-65535, OSPF/OSPFv3 process ID
NAME: VRF name to associate with this instance
router ipv6 ospf WORD NAME
Removes the configured VRF from OSPF process
no router ipv6 ospf WORD
NAME
You can run a specific OSPF/OSPFv3 process with same network and neighbor per VRF
instance, which was created with VPN Routing/Forwarding instance name using ip vrf
WORD command.
11.6.6.2 BGP
The BGP supports the feature to advertise the routing information between CE and PE,
and between PE and PE. Use the following command in order to enable address family
routing process, which open you in Address-Family Configuration mode.
address-family ipv4 vrf NAME
Opens the Address-Family-VRF Configuration
mode to enable the exchanging of IPv4/IPv6 VRF
routing information between PE and CE.
NAME: VRF name
address-family ipv6 vrf NAME
address-family vpnv4 [ unicast]
Opens the Address-Family-VPN Configuration
mode to exchange VPN routing information
among ISP PE-routers.
Exits to AF Configuration mode.
11.6.7 Establishing IP Static Routes for a VRF
To add a new static route entry for the specified interface, use the following command.
ip route vrf WORD A.B.C.D/M
GATEWAY INTERFACE [<1-255>]
Adds a new static entry to the VRF routing table.
WORD: VPN Routing/Forwarding instance name
A.B.C.D/M: IP destination prefix with mask
ip route vrf WORD A.B.C.D/M
To Next Page
Loading...