Dasan V5808 - Downloading Firmware to ONU (Upgrading); Specifying Default os of ONU; Restarting ONU

User Manual UMN:CLI
V5808
677
(2) Downloading Firmware to ONU (Upgrading)
To download the specified ONU (ONT) firmware in the ONU (ONT), use the following
command.
Command
Mode
Description
onu firmware download ONU-ID
FILE_NAME [os1 | os2]
GPON-OLT
Downloads ONU (ONT) firmware in the ONU (ONT).
ONU-ID: ONU ID (1-128) or ONU serial number
FILE_NAME: ONU firmware name
You can see the status of ONU firmware by the show onu firmware version command
as follows:
To display the status of ONU firmware, use the following command.
Command
Mode
Description
show onu firmware version OLT-
ID [ONU-IDs]
Enable
Global
GPON
Shows the status of ONU firmware.
OLT-ID: GPON port number
ONU-ID: ONU ID (1-128) or ONU serial number
show onu firmware version
[ONU-IDs]
GPON-OLT
Shows the status of ONU firmware.
ONU-ID: ONU ID (1-128) or ONU serial number
SWITCH(config-gpon-olt[1])# show onu firmware version
(D):Default-OS (R):Running-OS
-------------------------------------------------------------------------
OLT | ONU | Upgrade Status | OS1 | OS2
-------------------------------------------------------------------------
1 | 1 | - | #2.13m | (D)(R) #2.13m
(3) Specifying Default OS of ONU
To specify the default OS of ONU (ONT), use the following command.
Command
Mode
Description
onu firmware commit ONU-ID
[os1 | os2]
GPON-OLT
Specifies the default OS of ONU (ONT).
(4) Restarting ONU
In order to use the new upgraded firmware, you should restart the ONU (ONT). At this
time, the upgraded OS should be specified as a default OS by using onu firmware
commit command.
Before restarting the ONU (ONT), you should check the service status of ONU, whether
to save the other configuration, or else.
!
i