User Manual UMN:CLI
V5808
59
INIT: Entering runlevel: 3
INIT: Start UP
SWITCH login: admin
Password:
SWITCH>
The password of “admin” is restored to the factory default password (no password) if the
operator has not created any user accounts.
4.1.5 Management for System Account
4.1.5.1 Creating System Account
For the V5808, the administrator can create a system account. In addition, it is possible to
set the security level from 0 to 15 to enhance the system security.
To create a system account, use the following command.
user add NAME DESCRIPTION
Creates a system account.
user add NAME level <0-15>
DESCRIPTION
Creates a system account with a security level.
The account of level 0 to level 14 without any configuring authority only can use exit and
help in Privileged EXEC View mode and cannot access to Privileged EXEC Enable mode.
The account with the highest level 15 has a read-write authority.
To delete the created account, use the following command.
Delete the created account.
To display a created account, use the following command.
4.1.5.2 Security Level
For the V5808, it is possible to configure the security level from 0 to 15 for a system
account. The level 15, as the highest level, has a read-write authority. The administrator
can configure from level 0 to level 14. The administrator decides which level user uses
which commands in which level. As the basic right from level 0 to level 14, it is possible to
use exit and help command in Privileged EXEC View mode and it is not possible to
To Next Page
Loading...