Dasan V5808 - Terminal Configuration; Login Banner

User Manual UMN:CLI
V5808
113
[SERVER3]
no sntp
Disables SNTP function.
You can configure up to 3 servers so that you use second and third servers as backup
use in case the first server is down.
To display SNTP configuration, use the following command.
Command
Mode
Description
show sntp
Enable
Global
Bridge
Show SNTP configuration.
The following is to register SNTP server as 203.255.112.96 and enable it.
SWITCH(config)# sntp 203.255.112.96
SWITCH(config)# show sntp
==========================
sntpd is running.
==========================
Time Servers
--------------------------
1st : 203.255.112.96
==========================
SWITCH(config)#
6.1.6 Terminal Configuration
By default, the V5808 is configured to display 24 lines composed by 80 characters on
console terminal. You can change the number of displaying lines by using the terminal
length command. The maximum line displaying is 512 lines.
To set the number of the lines displaying on terminal screen, use the following command.
Command
Mode
Description
terminal length <0-512>
Enable
Sets the number of the lines displaying on a terminal
screen, enter the value.
no terminal length
Restores a default line displaying.
6.1.7 Login Banner
It is possible to set system login and log-out banner. Administrator can leave a message
to other users with this banner.
To set system login and log-out banner, use the following command.
i