UMN:CLI User Manual
V5808
64
4.1.7 Limiting the Number of login attemps
For security reasons of the system, Administrator can configure the number of the login
attempts. To configure the system login attempts, use the following command.
login attempts <1-5> delay <5-
60>
Sets login attempts.
1-5: number of retry login attempts (default: 5)
5-60: access delay time (default: 5 minutes)
To display a configuration of login attempts function, use the following command.
show login attempts log [USER]
Shows login attempt information
To delete or reset the configured login attempts, use the following command.
Resets the number of login attempts configured and
access delay time. (default:5 number , 5minutes)
clear login attempts log [USER]
Deletes the login attempt information.
4.1.8 Auto Log-out
For security reasons of the V5808, if no command is entered within the configured
inactivity time, the user is automatically logged out of the system. Administrator can
configure the inactive session timeout.
To enable auto log-out function, use the following command.
exec-timeout <1-35791> [<0-59>]
Enables auto log-out.
1-35791: time unit in minutes (by default 10 minutes)
0-59: time unit in seconds
To display a configuration of auto-logout function, use the following command.
Shows a configuration of auto-logout function.
To Next Page
Loading...