Dasan V5808 - Displaying RIP Protocol Information; Displaying Debugging Information

UMN:CLI User Manual
V5808
600
databases. Information provided can be used to determine resource utilization and solve
network problems. You can also discover the routing path your router’s packets are taking
through the network.
11.4.16.1 Displaying RIP Protocol Information
To display RIP information, use the following command.
Command
Mode
Description
show ip rip [database]
Enable
Global
Bridge
Shows RIP information being used in router.
show ip route [database] rip
Shows a routing table information involved in RIP.
show ip protocols [rip]
Shows a current status of RIP protocol and its
information.
show ip rip interface
[INTERFACE]
Enable
Shows RIP information of specified interface.
To clear RIP information being used in router, use the following command.
Command
Mode
Description
clear ip rip route [bgp | connected | kernel |
ospf | rip | static | all | A.B.C.D/M]
Enable
Global
Bridge
Deletes RIP information being used in
router.
11.4.16.2 Displaying Debugging Information
To quickly diagnose problems, the debug command is useful for customers. To enable
debugging of RIP routing transactions, use the following command.
Command
Mode
Description
debug rip [all]
Enable
Turns on all debugging options of changed RIP
information.
debug rip events
Enables a debugging of RIP event such as packet
transmit and sending and changed RIP information.
debug rip nsm
Enables RIP nsm debugging.
debug rip packet [recv | send]
Shows more detailed information about RIP packet.
The information includes address of packet
transmission and port number.
debug rip packet [recv | send]
detail
To disable debugging of RIP routing transactions, use the following command.
Command
Mode
Description
no debug rip [all]
Enable
Turns off all debugging options of changed RIP
information.
no debug rip events
Disables a debugging of RIP event such as packet
transmit and sending and changed RIP information.
no debug rip nsm
Disables RIP nsm debugging.