UMN:CLI User Manual
V5808
228
After one of entries is displayed as a syslog message, it is removed in the order in which
the entries appear in the list.
To configure the options of log-buffer function, use the following command.
ip arp inspection log-buffer
entries <0-1024>
Specifies the number of entries in log-buffer.
0-1024: the max. number of entries (default: 32)
ip arp inspection log-buffer
logs <0-1024> interval <0-
86400>
Sets the interval for displaying syslog messages of
entries.
0-1024: the number of syslog messages per specified
interval (default: 5)
0-86400: interval value in second (default: 1 sec)
To delete the configured options of log-buffer function, use the following command.
no ip arp inspection log-buffer
{entries | logs}
Deletes the configured options of log-buffer function.
To display the configured log-buffer function and entries’ information, use the following
command.
show ip arp inspection log
Displays the configured log-buffer function.
To clear all of collected entries in the list, use the following command.
clear ip arp inspection log
Clears all of collected entires in the log-buffer list.
7.15.4.6 Displaying ARP Inspection
To display a status of the ARP inspection, use the following command.
show ip arp inspection [vlan
VLANS]
Shows a status of the ARP inspection.
show ip arp inspection statistics
[vlan VLANS]
Shows collected statistics of the ARP inspection.
To Next Page
Loading...