UMN:CLI User Manual
V5808
618
11.6.10 VRF Network Connection (PING)
To check if your system is correctly connected to the network, use the ping command.
For IP network, this command transmits a message to internet control message protocol
(ICMP). ICMP is an internet protocol that notifies fault situation and provides information
on the location where IP packet is received. When the ICMP echo message is received at
the location, its replying message is returned to the place where it came from.
To perform a ping test to display network status, use the following command.
Performs a ping test to verify network status.
WORD: destination IPv4 address or hostname
NAME: VPN routing/forwarding instance name
ping ipv6 WORD [INTERFACE]
Performs a ping test to verify network status.
WORD: destination IPv6 address or hostname
INTERFACE: VRF interface name
11.6.11 Displaying VRF Information
To display a list of all virtual routers and their descriptions, use the following command.
Shows a list of all virtual routers and their descriptions.
WORD: VPN routing/forwarding instance name
To display the contents of the running configuration on a virtual router, use the following
command.
show running-config vrf WORD
Shows the running configuration for a specific virtual
router.
WORD: VPN routing/forwarding instance name
To Next Page
Loading...