Dasan V5808 - Port Debounce Timer

User Manual UMN:CLI
V5808
105
threshold configuration).
show arp port PORTS
Shows the information of ARP port.
The show port module-info command is only valid for Ethernet optical port. In case of
using the command on the PON interface, even if the interface is equipped with the PON
module, the system shows the state as Uninstalled.
5.1.12 Port Debounce Timer
The V5808 can be configured to enable the debounce timer for Ethernet ports by specifying a
debounce time (in milliseconds) or disable the timer by specifying a debounce time of 0.
To enable/disable the debounce timer, use the following command.
Command
Mode
Description
port link-debounce-time PORTS
<0-5000>
Bridge
Enables the debounce timer for the amount of time (1
to 5000)
Disables the debounce timer if you specify 0 (ms)
PORTS: port number
0-5000: time (ms)
no port link-debounce-time
PORTS
Deletes the configured debounce timer.
show port link-debounce
[PORTS]
Enable
Global
Bridge
Shows the configured port link-debounce time.
!