User Manual UMN:CLI
V5808
593
no ip rip receive version 1
Deletes the configuration of RIP v1 type packet for
helping them be received from the interface.
no ip rip receive version 2
Deletes the configuration of RIP v2 type packet for
helping them to be received from interface.
no ip rip receive version 1 2
Deletes the configuration of both RIP v1 and RIP v2
type packets for helping them to be received from the
interface.
To enable/disable receiving RIP route information through the specified interface, use the
following command.
Enables this interface to receive the RIP route
informatin.
Disables this interface to receive RIP route information.
11.4.4 Creating available Static Route only for RIP
This feature is provided only by DASAN Network Solutions’ route command creates static
route available only for RIP. If you are not familiar with RIP protocol, you would better use
redistribute static command.
Creates suitable static route within RIP environment
only.
A.B.C.D/M: IP prefix
Deletes this static route established by route
command.
11.4.5 Redistributing Routing Information
The V5808 can redistribute the routing information from a source route entry into the RIP
tables. For example, you can instruct the router to re-advertise connected, kernel, or
static routes as well as other routes established by routing protocol. This capability
applies to all the IP-based routing protocols. To redistribute routing information from a
source route entry into the RIP table, use the following command.
redistribute {kernel | connected |
static | ospf | bgp}
Registers transmitted routing information in another
router’s RIP table.
1-16: metric value
WORD: pointer to route-map entries
redistribute {kernel | connected |
static | ospf | bgp } metric <0-16>
redistribute {kernel | connected |
static | ospf | bgp } route-map
WORD
To Next Page
Loading...