UMN:CLI User Manual
V5808
592
The preceding task controls default RIP version settings. You can override the routers RIP
version by configuring a particular interface to behave differently.
To control which RIP version an interface sends, perform one of the following tasks after
opening Interface Configuration mode.
Sends RIP v1 type packet only to this interface.
Sends RIP v2 type packet only to this interface.
Sends RIP v1 and RIP v2 type packets both.
To delete the configuration that sends RIP version packet to interface, use the following
command.
Deletes the configuration of RIP v1 type packet for
helping them to be sent to the interface.
Deletes the configuration of RIP v2 type packet for
helping them to be sent to the interface.
no ip rip send version 1 2
Deletes the configuration of both RIP v1 and v2 type
packets for helping them to be sent to the interface.
To enable/disable sending RIP route information through the specified interface, use the
following command.
Enables this interface to send the RIP route
information.
Disables this interface to send the RIP route
information.
Similarly, to control how packets received from an interface are processed, perform one of
the following tasks.
Receives RIP v1 type packet only from the interface.
Receives RIP v2 type packet only from the interface.
ip rip receive version 1 2
Receives both RIP v1 and RIP v2 type packets from
the interface.
To delete the configuration that receives RIP version packet from the interface, use the
following command.
To Next Page
Loading...