Dasan V5808 - Enabling MSTP Configuration

User Manual UMN:CLI
V5808
305
To delete the configuration ID setting, use the following command.
Command
Mode
Description
no name
MST-config
Deletes the name of MSTP region
no instance <1-64> vlan VLANS
Deletes part of vlan-mapping, select the instance ID
number and vlan id to remove from the specified
instance
1-64: instance ID number
VLANS: VLAN ID (1-4094)
no revision
Deletes the configured revision number.
After configuring the configuration ID in the V5808, you should apply the configuration to
the switch. After changing or deleting the configuration, you must apply it to the switch. If
not, it does not being reflected into the switch.
To apply the configuration to the system, use the following command.
Command
Mode
Description
apply
MST-config
Apllies the configuration of the region to the system.
After deleting the configured configuration ID, apply it to the system using the above
command.
To display the current and edited configuration on MSTP Configuration mode, use the
following command.
Command
Mode
Description
show current
MSTP
Shows the current configuration as it is used to run
MSTP
show pending
Shows the edited configuration of MSTP.
show
Shows all configurations of MSTP
For example, after setting the configuration ID, if you apply it to the switch with the apply
command, you can check the configuration ID with the show current command.
However, if the user did not use the apply command to apply the configurations to the
switch, the configuration could be checked with the show pending command.
8.3.6.2 Enabling MSTP configuration
To enable/disable a MSTP daemon by applying MSTP configurations to the system, use
the following command.
Command
Mode
Description
spanning-tree mst
Bridge
Enables MSTP function on the system
no spanning-tree mst
Disables MSTP function on the system.
i