User Manual UMN:CLI
V5808
233
Deletes a configured interval between IPv6 RA messages
The interval value should be less than or equal to the IPv6 Router Lifetime if this is a
default router.
7.16.4 RA Destination Configuration
To configure the destination address of solicited RA (Router Advertisement) message
which is supplied from source address of RS (Router Solicitation), use the following
command.
ipv6 nd ra-destination rs
Configures the IPv6 router advertisement destination
address.
rs: router solicited source address
no ipv6 nd ra-destination rs
Deletes the configured IPv6 router advertisement
destination address.
7.16.5 Router’s Lifetime
This value is included in all IPv6 Router Advertisements sent out this interface. If the
router is not a default router, this will have a value of zero. The default value is 1,800
seconds.
To configure the lifetime of a RA messages, use the following command.
ipv6 nd ra-lifetime <0-9000>
Specifies the lifetime of IPv6 RA message. (default:
1800 seconds)
Deletes a configured lifetime of IPv6 RA message
If the router is a default router, this value will be non-zero and should not be less than the
minimum Router Advertisement interval.
7.16.6 Reachable Time
RA reachable time is the amount of time that a remote IPv6 node is reachable for a
specified time after a reachable confirmation event. The reachable time enables detecting
unavailable neighbors. The configured reachable time is included in all router
advertisements sent out of an interface so that nodes on the same link use the same time
value.
To specify the reachable time that the switch can reach a remote IPv6 node after the
reachability confirmation event has occurred, use the following command.
ipv6 nd reachable-time <0-
Specifies the reachable time.
0-3600000: IPv6 reachable time in milliseconds (A
To Next Page
Loading...