Dasan V5808 - ONU RX-Power Update; Configurations for RF Return Packet Forwarding

UMN:CLI User Manual
V5808
634
VID: VID
To display the user configuration of the OLT anti-spoofing, use the following command.
Command
Mode
Description
show olt anti-spoofing [OLT-ID]
Enable
Global
GPON
Shows the user configuration of the OLT anti-spoofing.
show olt anti-spoofing
GPON-OLT
To display the current OLT anti-spoofing status, use the following command.
Command
Mode
Description
show olt anti-spoofing status
OLT-ID
Enable
Global
GPON
Shows the current anti-spoofing MAC filtering status
per ONU, MAC and VID.
show olt anti-spoofing status
GPON-OLT
12.1.11 ONU RX-Power Update
To configure the interval of ONU rx-power update, use the following command.
Command
Mode
Description
onu rx-power update {<1-1440> |
disable}
GPON
Configures the interval of ONU rx-power update.
1-1440: interval (unit: minute)
disable: do not update
To display the configuration of ONU rx-power update, use the following command.
Command
Mode
Description
show onu rx-power update
Enable
Global
GPON
GPON-OLT
Shows the configuration of ONU rx-power update.
12.1.12 Configurations for RF Return Packet Forwarding
In case the ONUs are connected with the set-top-boxes supporting Ethernet return path
capabilities, GPON OLT can use Ethernet for the return path to head-end infrastructure.
Deploying an ONU/MDU with an RF to Ethernet converter enables RF-digital-RF
conversion. At the ONU, the upstream return path packet is carried in GPON OLT. The
GPON OLT aggregates the packets from the ONUs and sends them to the Ethernet to RF
converter as the head-end node. This RF converter converts the Ethernet signals to back