Dasan V5808 - Applying and Modifying Admin Flow

UMN:CLI User Manual
V5808
196
Command
Mode
Description
ipv6 { X:X::X:X | X:X::X:X/M | any}
{X:X::X:X |X:X::X:X/M | any} udp {<1-
65535> | any} {<1-65535> | any}
any: any source/destination IPv6 address
0-65535: TCP/UDP port range
any: any TCP/UDP port
TCP_FLAG: TCP flag vlaue
To delete a specified packet-classifying pattern, use the following command.
Command
Mode
Description
no ip
Admin-Flow
Deletes a specified packet-classifying pattern for each
option.
no ipv6
no ip header-length
7.5.6.3 Applying and modifying Admin Flow
After configuring an admin flow using the above commands, apply it to the system with
the following command. If you do not apply it to the system, all specified configurations
from Admin-Flow Configuration mode will be lost.
To save and apply an admin flow, use the following command.
Command
Mode
Description
apply
Admin-Flow
Applies an admin flow to the system.
To modify an admin flow, use the following command.
Command
Mode
Description
flow admin NAME modify
Global
Modifies a flow, enter an admin flow name.
You should save and apply the admin flow to system using apply command whenever
you modify any configuration of the admin flow.
7.5.6.4 Class Creation
One class can include several flows. You can simply handle and configure the packets on
several flows at once.
To create a class including more than 2 flows, use the following command.
Command
Mode
Description
class admin NAME flow FLOW1
[FLOW2] [FLOW3]
Global
Creates an admin class including at least 2 admin
flows.
NAME: admin class name
FLOW: admin flow name
To delete configured admin class or all admin classes, use the following command.
i