Dasan V5808 - STP Mode; STP Basic Configuration; Path-Cost Method

User Manual UMN:CLI
V5808
299
8.3.4 STP Mode
First of all, you need to enable STP function. You cannot configure any parameters
related to Spanning Tree Protocol without this command.
To enable STP function on the V5808, use the following command.
Command
Mode
Description
spanning-tree
Bridge
Enables STP function.
To disable STP function from the system, use the following command.
Command
Mode
Description
no spanning-tree
Bridge
Disables STP function.
To select the spanning tree mode, use the following command.
Command
Mode
Description
spanning-tree mode { mst |
rapid-pvst | stp | rstp}
Bridge
Configures a spanning-tree mode:
mst: Multiple Spanning Tree Protocol (default)
rapid-pvst: Per-vlan Rapid STP
To delete the configured spanning tree mode, use the following command.
Command
Mode
Description
no spanning-tree mode
Bridge
Deleted a configured spanning tree mode. (default:
MSTP)
8.3.5 STP Basic Configuration
To configure STP, use the following steps.
Step 1
Enable STP function using the spanning-tree command.
Step 2
Configure detail options if specific commands are required.
8.3.5.1 Path-cost Method
After deciding a root switch, you need to decide to which route you will forward the packet.
To do this, the standard is a path-cost.
Generally, a path cost depends on the transmission speed of LAN interface in the switch.
The following table shows the path cost according to the transmit rate of LAN interface.
You can use same commands to configure STP and RSTP, but their path-costs are to-
tally different. Please be careful not to make mistake.