Dasan V5808 - Rate-Limit; Applying and Modifying Policer; Rule Action; Policy Creation

User Manual UMN:CLI
V5808
183
Global
Bridge
To display the number of packets on each rule, use the following command.
Command
Mode
Description
show flow statistics
Enable
Global
Shows a collected flow counter.
show class statistics
Shows a collected class counter.
show policer statistics
Shows a collected policer counter.
show policy statistics
Shows a collected policy counter.
7.5.3.3 Rate-limit
You can configure the rate limit in kbps unit for the classified packets and control the
bandwidth. To set the bandwidth of classified packets in specified policer, use the
following command.
Command
Mode
Description
rate-limit BANDWIDTH
Policer
Sets the bandwidth for classified packets belonging to
specified policer (unit: kbps)
no rate-limit
Deletes the configured bandwidth for classified packets
of specified policer.
7.5.3.4 Applying and modifying Policer
After configuring a policer using the above commands, apply it to the system with the
following command. If you do not apply the policer to the system, all specified
configurations on Policer Configuration mode will be lost.
To save and apply a policer, use the following command.
Command
Mode
Description
apply
Policer
Applies a policer to the system.
To modify a policer, use the following command.
Command
Mode
Description
policer NAME modify
Global
Modifies a policer, enter a policer name.
7.5.4 Rule Action
7.5.4.1 Policy Creation
To configure a policy, you need to open Policy Configuration mode first. To open Policy
Configuration mode, use the following command.