Dasan V5808 - Multicast Profile; Creating Multicast Profile; IGMP Configurations

UMN:CLI User Manual
V5808
784
12.11 Multicast Profile
The multicast profile is used for ONU (ONT) to handle the multicast traffic using a IGMP-
related commands. Multicast profile managed entity organizes data associated with
multicast management at subscriber ports of 802.1 bridges, including 802.1p mappers
when the provisioning model is mapper-based rather than bridge-based. Instances of this
managed entity are created and deleted by the OLT. It is the responsibility of the OLT to
manage the members of a multicast group and control the multicast connection in ONTs
12.11.1 Creating Multicast Profile
To create a multicast profile, use the following command.
Command
Mode
Description
multicast-profile NAME create
GPON
Creates a multicast profile.
NAME: multicast profile name
After opening Multicast Profile Configuration mode, the prompt changes from
SWITCH(gpon)# to SWITCH(config-mcast-profile[NAME])#.
To delete a created multicast profile, use the following command.
Command
Mode
Description
no multicast-profile {NAME | all}
GPON
Deletes a created multicast profile.
NAME: multicast profile name
To modify an existing multicast profile, use the following command.
Command
Mode
Description
multicast-profile NAME modify
GPON
Modifies the existing multicast profile.
NAME: multicast profile name
12.11.2 IGMP Configurations
To configure the multicast profile, use the following command.
Command
Mode
Description
igmp version <1-3>
Multicast-
Profile
Sets an IGMP version on a current interface.
1-3: IGMP version (default: 2)
igmp function snooping
Enables the IGMP snooping.
igmp function suppression
Enables the IGMP snooping with proxy reporting
(SRP).
igmp function proxy
Enables the IGMP proxy.
igmp immediate-leave enable
Enables the IGMP immediate leave. (Default: enable)