Dasan V5808 - Timeout of Authentication Request; Frequency of Retransmit; TACACS+ Server for System Authentication; TACACS+ Server Priority

UMN:CLI User Manual
V5808
72
4.2.4.3 Timeout of Authentication Request
After an authentication request, the V5808 waits for a response from a RADIUS server for
specified time.
To specify a timeout value, use the following command.
Command
Mode
Description
login radius timeout <1-100>
Global
Specifies a timeout value.
1-100: timeout value for a response (default: 5)
no login radius timeout
Deletes a specified timeout value.
4.2.4.4 Frequency of Retransmit
In case of no response from a RADIUS server, the V5808 is supposed to retransmit an
authentication request. To set the frequency of retransmitting an authentication request,
use the following command.
Command
Mode
Description
login radius retransmit <1-10>
Global
Sets the frequency of retransmit.
1-10: frequency count (default: 3)
no login radius retransmit
Deletes a specified frequency count.
4.2.5 TACACS+ Server
4.2.5.1 TACACS+ Server for System Authentication
To add/delete the TACACS+ server for system authentication, use the following command.
Command
Mode
Description
login tacacs server A.B.C.D KEY
Global
Adds a TACACS+ server with its information.
A.B.C.D: IP address
KEY: authentication key value
no login tacacs server [A.B.C.D]
Deletes an added TACACS+ server.
A.B.C.D: IP address
You can add up to 5 TACACS+ servers.
4.2.5.2 TACACS+ Server Priority
To specify the priority of a registered TACACS+ server, use the following command.
Command
Mode
Description
login tacacs server move
A.B.C.D <1-5>
Global
Specifies the priority of TACACS+ server.
A.B.C.D: IP address
1-5: priority of TACACS server
i