Dasan V5808 - Protocol Statistics; Port Information

UMN:CLI User Manual
V5808
104
no cpu statistics-limit all
{PORTS | all}
Disables the switch to generate a syslog message
according to the number of the packets handled by
CPU for all packet types.
To display a configured value to generate a syslog message according to the number of
the packets handled by CPU, use the following command.
Command
Mode
Description
show cpu statistics-limit
Enable
Global
Bridge
Shows a configured value to generate a syslog
message according to the number of the packets
handled by CPU.
5.1.10.3 Protocol Statistics
To enables/disables the system to collect the statistics of the protocols, use the following
command.
Command
Mode
Description
protocol statistics {enable |
disable} [arp | icmp | ip | tcp |
udp]
Global
Bridge
Enables/disables the system to collect the statistics of
the protocols. (ARP, ICMP, IP, TCP, UDP)
To display the statistics of the protocol, use the following command.
Command
Mode
Description
show protocol statistics avg-pkt
[PORTS]
Enable
Global
Bridge
Shows the statistics of the protocol for average
packets.
show protocol statistics total
[PORTS]
Shows the traffic statistics of the protocol for total
packets.
To delete the collected statistics of the protocol, use the following command.
Command
Mode
Description
clear protocol statistics [PORTS]
Global
Bridge
Deletes the collected statistics of the protocol.
5.1.11 Port Information
To display the port information, use the following command.
Command
Mode
Description
show port [PORTS]
Enable
Global
Bridge
Shows a current port status, enter a port number.
PORTS: port number
show port status [PORTS]
show port description [PORTS]
Shows a specified port description, enter a port
number.
show port module-info [PORTS]
Shows the information of SFP module (including