UMN:CLI User Manual
V5808
588
no max-concurrent-dd
<1-65535>
Deletes the configuration.
11.3.14.5 Displaying Debugging Information
The V5808 uses debug command to find the reason of problem. Use the following
command.
Shows all the debugging information.
debug ipv6 ospf events [abr | asbr |
os | router | vlink | nssa]
Shows information about OSPF operation of OSPF
neighbor router, transmitted information, deciding
destination router, calculating the shortest route,
and so on.
debug ipv6 ospf ifs
m [events | status | timers]
Shows the debugging information of OSPF
interface.
debug ipv6 ospf lsa [flooding |
generate | refresh | install | maxage]
Shows information transmitted by OSPF and
calculating the shortest route.
debug ipv6 ospf nfsm [events |
status | timers]
Shows the debugging information of OSPF
Neighbor router.
debug ipv6 ospf nsm [interface |
redistribute]
Shows the debugging information between OSPF
process and NSM (Network Services Module).
debug ipv6 ospf packet [{hello | dd |
ls-ack | ls-request | ls-update | send
| recv | detail}]
Shows the debugging information of each packet.
debug ipv6 ospf route [ase | ia |
install | spf]
Shows the debugging information of OSPF routing.
To turn off the debugging information according to an option, use the following command.
Turns off the debugging information of
OSPFv3.
no debug ipv6 ospf events [abr | asbr | os |
router | vlink | nssa]
no debug ipv6 ospf ifsm [events | status | timers]
no debug ipv6 ospf lsa [flooding | generate |
refresh | install | maxage]
no debug ipv6 ospf nfsm [events | status |
timers]
no debug ipv6 ospf nsm [interface | redistribute]
no debug ipv6 ospf packet [{hello | dd | ls-ack |
ls-request | ls-update | send | recv | detail}]
no debug ipv6 ospf route [ase | ia | install | spf]
To display the debugging information, use the following command.
To Next Page
Loading...