User Manual UMN:CLI
V5808
587
To configure the format of displaying OSPFv3 routing table, use the following command.
ipv6 ospf display route single-
line
Configures the format of displaying entries in OSPFv3
routing table in single line.
no ipv6 ospf display route
single-line
Deletes a configured format of displaying OSPFv3
routing table.
To display the information of virtual link, use the following command.
show ipv6 ospf [WORD] virtual-links
Shows the information of virtual link.
11.3.14.2 Sending SNMP Trap
To enable/disable the system to send SNMP trap message of OSPFv3 routing information,
use the following command.
ipv6 ospf snmp-notification
enable
Configures the system to send SNMP trap of routing
information while OSPFv3 is running.
ipv6 ospf snmp-notification
disable
Disables the system to send SNMP trap of routing
information while OSPFv3 is running.
11.3.14.3 Logging Neighbor Changes
To enable/disable the system to log changes in OSFPv3 neighbors’ state such as system
up/down and reset, use the following command.
ospf log-neighbor-changes
Enables logging of OSPFv3 neighbor state changes
no ospf log-neighbor-changes
Disables logging of OSPFv3 neighbor state changes
11.3.14.4 Limiting Number of Database
The V5808 can limit the Number of Database to process in OSPF. For example, if a
router connected with many of routers, it carries overload to process the database.
Therefore, Limiting the Number of Database reduces the overload on system.
To configure the limiting Number of Database, use the following command.
max-concurrent-dd <1-65535>
Configures the limiting Number of Database.
To delete the configuration, use the following command.
To Next Page
Loading...