Dasan V5808 - Displaying MRIB Statistics; Displaying MFIB Information

UMN:CLI User Manual
V5808
444
9.3.1.6 Displaying MRIB Statistics
To display the multicast routing statistics entries in the MRIB, use the following command.
Command
Mode
Description
show ip mroute count
Enable
Global
Bridge
Shows all multicast routing statistics entries.
show ip mroute {dense | sparse}
count
Shows the multicast routing statistics entries for a
given PIM mode.
dense: dense mode
sparse: sparse mode
show ip mroute A.B.C.D [dense |
sparse] count
Shows the multicast routing statistics entries for a
given group.
A.B.C.D: group address
show ip mroute A.B.C.D A.B.C.D
[dense | sparse] count
Shows the multicast routing statistics entries for a
given group and source.
A.B.C.D: group/source address
show ip mroute A.B.C.D/M
[dense | sparse] count
Shows the multicast routing statistics entries for a
given group range.
A.B.C.D/M: group address and prefix
To delete the multicast routing statistics entries from the multicast routing table, use the
following command.
Command
Mode
Description
clear ip mroute statistics *
Enable
Global
Bridge
Deletes all multicast routing statistics entries.
clear ip mroute statistics
A.B.C.D [A.B.C.D]
Deletes a specific multicast routing statistics entry.
A.B.C.D: group/source address
9.3.1.7 Displaying MFIB Information
The multicast forwarding information base (MFIB) is the group of the information to
forward multicast traffic in Layer 3, which is maintained by currently running multicast
routing protocol. You can verify the forwarding entries in the MFIB with the show ip mfib
command.
To display the multicast forwarding entries in the MFIB, use the following command.
Command
Mode
Description
show ip mfib [vlan VLANS |
group A.B.C.D] [detail]
Enable
Global
Bridge
Shows the multicast forwarding entries in the MFIB.
VLANS: VLAN ID (1-4094)
A.B.C.D: multicast group address