Dasan V5808 - Signalling Code; To Enable;Disable RTP Piggyback Events; To Enable;Disable Handling of Tones Via RTP Tone Events; To Enable;Disable Handling of DTMF Via RTP DTMF Events

User Manual UMN:CLI
V5808
755
To enable/disable RTP piggyback events, use the following command.
Command
Mode
Description
rtp-piggyback-event {enable |
disable}
VoIP-Profile
Enables/disables RTP piggyback events. (default:
disable)
To enable/disable handling of tones via RTP tone events, use the following command.
Command
Mode
Description
rtp-tone-event {enable | disable}
VoIP-Profile
Enables/disables handling of tones via RTP tone
events per IETF RFC4733 and IETF RFC4734.
(default: disable)
To enable/disable handling of DTMF via RTP DTMF events, use the following command.
Command
Mode
Description
rtp-dtmf-event {enable | disable}
VoIP-Profile
Enables/disables handling of DTMF via RTP DTMF
events per IETF RFC4733 and IETF RFC 4734.
(default: disable)
This configuration is ignored unless out-of-band DTMF
in the VoIP media configuration is enabled. (For out-of-
band DTMF, see oob-dtmf command in 12.7.4 Saving
VoIP Profile.)
To enable/disable handling of CAS via RTP CAS events, use the following command.
Command
Mode
Description
rtp-cas-event {enable | disable}
VoIP-Profile
Enables/disables handling of CAS via RTP CAS events
per IETF RFC4733 and IETF RFC4734.
(default: disable)
12.7.1.5 Signalling Code
To specify the POTS-side signalling, use the following command.
Command
Mode
Description
signaling-code {loop-start |
ground-start | loop-reverse-
battery | coin-first | dial-tone-
first | multi-party }
VoIP-Profile
Specifies the POTS-side signalling.