Dasan V5808 - Displaying LLDP Configuration

User Manual UMN:CLI
V5808
159
To configure delay time of transmitting LLDP frame, use the following command.
Command
Mode
Description
lldp txdelay <1-8192>
Bridge
Configures delay time of transmitting LLDP frame.
(default: 2)
7.2.7 Displaying LLDP Configuration
To display LLDP configuration, use the following command.
Command
Mode
Description
show lldp config [PORTS]
Enable
Global
Bridge
Shows LLDP configuration.
show lldp remote [PORTS]
Show statistics for remote entries.
show lldp statistics [PORTS]
Shows LLDP operation and statistics.
To delete an accumulated statistics on the port, use the following command.
Command
Mode
Description
clear lldp statistics [PORTS]
Enable
Global
Bridge
Deletes an accumulated statistics on the port.