Dasan V5808 - MLD Static Join; Displaying MLD Information

User Manual UMN:CLI
V5808
471
10.1.6.6 MLD Static Join
The MLD static join feature has been developed to reduce the zapping time by statically
creating a virtual host that behaves like a real on a port, even if there is no group member
in the group where the port belongs. As a result, a multicast router realizes there is still
group member, allowing multicast traffic to be permanently reachable on the group.
To configure the MLD static join, use the following command.
Command
Mode
Description
ipv6 mld static-group X:X::X:X port PORT
[source {SOURCE | ssm-map]
Interface
Configures the MLD static join.
X:X::X:X: MLD group address
SOURCE: source address X:X::X:X
reporter: host address
no ipv6 mld static-group X:X::X:X port PORT
[source {SOURCE | ssm-map]
Deletes the configured MLD static join.
10.1.7 Displaying MLD Information
To display current MLD groups and relevant information, use the following command.
Command
Mode
Description
show ipv6 mld groups detail
Enable
Global
Shows the multicast groups with receivers directly
connected to the router and learned through MLD.
X:X::X:X: IPv6 multicast group address
IFNAME: interface name
show ipv6 mld groups X:X::X:X
[detail]
show ipv6 mld groups IFNAME
[detail]
show ipv6 mld groups IFNAME
X:X::X:X [detail]
show ipv6 mld interface IFNAME