Dasan V5808 - SNMP Trap Mode; SNMP Trap Host

UMN:CLI User Manual
V5808
148
taddr1 param1 10.70.1.163 162 1500 3 tag1 tag3
SWITCH(config)# show snmp notify
Notify Table
NotifyName Tag Type
------------------------------------------
n5 tag5
SWITCH(config)#
7.1.12 SNMP Trap
SNMP trap is an alert message that SNMP agent notifies SNMP manager about certain
problems. If you configure the SNMP trap, the system transmits pertinent information to
network management program. In this case, trap message receivers are called a trap
host.
7.1.12.1 SNMP Trap Mode
To select the SNMP trap mode, use the following command.
Command
Mode
Description
snmp trap-mode {alarm-report |
event}
Global
Selects the SNMP trap mode.
alarm-report: alarm report based trap
event: event based trap (default)
7.1.12.2 SNMP Trap Host
To set an SNMP trap host, use the following command.
Command
Mode
Description
snmp trap-host {A.B.C.D | X:X::X:X}
[COMMUNITY]
Global
Specifies an SNMP trap v1 host.
snmp trap2-host {A.B.C.D | X:X::X:X}
[COMMUNITY]
Specifies an SNMP trap v2 host.
snmp inform-trap-host {A.B.C.D | X:X::X:X}
[COMMUNITY]
Specifies an SNMP inform trap host.
To delete a specified SNMP trap host, use the following command.
Command
Mode
Description
no snmp trap-host {A.B.C.D |
X:X::X:X }
Global
Deletes a specified SNMP trap v1 host.
no snmp trap2-host {A.B.C.D |
X:X::X:X }
Deletes a specified SNMP trap v2 host.
no snmp inform-trap-host
Deletes a specified SNMP inform trap host.