Dasan V5808 - Page 147

User Manual UMN:CLI
V5808
147
no snmp notify NOTIFY
Deletes the defined notification.
To display information for the notify type, use the following command.
Command
Mode
Description
show snmp notify
Enable
Global
Shows information for the notify type.
The following is an example of configuring SNMPv3 trap notification.
SWITCH(config)# snmp engine-id hex 80:00:05:23:01:0A:46:01:A3
SWITCH(config)# show snmp engine-id
Local SNMP Engine ID
Type Engine ID
--------------------------------
hex 80:00:05:23:01:0A:46:01:A3
SWITCH(config)# snmp com2sec com2-test 1.1.2.0/24 mmm
SWITCH(config)# snmp com2sec com2-pakih 10.70.1.163 powertest
SWITCH(config)# snmp user pakih md5 test1234 des des12345
SWITCH(config)# snmp targetparams param1 v1 com2-pakih
SWITCH(config)# snmp targetparams param3 v3 pakih auth
SWITCH(config)# snmp targetparams sss v3 pakih noauth
SWITCH(config)# snmp targetaddr taddr1 param1 10.70.1.163 162 1500 3 tag1 tag3
SWITCH(config)# snmp targetaddr no1 sss 10.70.1.163 162 1500 3 tag5
SWITCH(config)# snmp targetaddr a1 sss 1.1.1.1
SWITCH(config)# snmp notify n5 tag5
SWITCH(config)# show snmp com2sec
Com2Sec List
SecName Source Community
------------------------------------------------
com2-test 1.1.2.0/24 mmm
com2-pakih 10.70.1.163 powertest
SWITCH(config)# show snmp user
User List
Name AuthMode AuthPassphrase PrivMode PrivPassphrase
---------------------------------------------------------------------
pakih md5 test1234 des des12345
SWITCH(config)# show snmp targetparams
Targetparam Table
TargetparamName SecModel SecName SecLevel
------------------------------------------------------
param1 v1 com2-pakih
param3 v3 pakih auth
sss v3 pakih noauth
SWITCH(config)# show snmp targetaddr
Targetaddr Table
TargetaddrName TargetparamsName Address Port Timeout Retries Taglist
------------------------------------------------------------------------------
a1 sss 1.1.1.1
no1 sss 10.70.1.163 162 1500 3 tag5