UMN:CLI User Manual
V5808
528
To reset all dampened BGP routes, use the following command.
Resets all dampened BGP routes.
clear ip bgp dampening {A.B.C.D
| A.B.C.D/M}
To clear the flap count and history duration for all the prefixes under the specified address
family, use the following command.
clear ip bgp flap-statistics
Clears the collected BGP flap statistics.
clear ip bgp flap-statistics
{A.B.C.D | A.B.C.D/M}
11.1.10 BGP Session Reset
When you manage BGP network, you can use the command to reset the session for all
peers occasionally. Because the internal connections are re-established newly after
resetting, the route information of the connected routers is restored by default.
You can reset the session in specified condition. The V5808 is available with several
parameters to reset the BGP connections.
11.1.10.1 Session Reset of All Peers
To reset the sessions with all BGP peers, use the following command.
Resets all sessions with BGP peer groups.
When the route parameters restore to the default value by reset command, you can
configure the specific parameters for its initialization. If you would like to reset/clear the
outgoing advertised routes only, you should use out parameter. Otherwise, if you’d like to
reset/clear the incoming advertised routes only, you should use in parameter.
Meanwhile, if prefix-filter is configured with in option, ORF (Outbound Route Filtering)
and incoming route can be reset. By using soft option, you can configure the switch to
update route information only when the session is still connected.
To reset the sessions of all peers and initialize the details of route configurations, use the
To Next Page
Loading...
Need help?
General