Dasan V5808 - LLDP Message; Reinitiating Delay

UMN:CLI User Manual
V5808
158
For the V5808, the administrator can enable and disable basic TLV by selecting it. To
enable basic TLV by selecting it, use the following command.
Command
Mode
Description
lldp PORTS {portdescription |
sysname | sysdescription |
syscap}
Bridge
Selects basic TLV that to be sent in the port.
portdescription: port description
sysname: system name
sysdescription: system description
syscap: system capability
no lldp PORTS {portdescription |
sysname | sysdescription |
syscap}
Disables basic TLV configured to be sent in the port.
To specify TLV location ID that is ELIN (Emergency Location Identification Number), use
the following command.
Command
Mode
Description
lldp locationID ELIN
Bridge
Specifies TLV location ID.
ELIN: TLV location ID
no lldp locationID
Deletes the specified TLV location ID.
7.2.5 LLDP Message
For the V5808, it is possible to configure the interval time and times of sending LLDP
message. To configure the interval time and times of LLDP message, use the following
command.
Command
Mode
Description
lldp msg txinterval <5-32768>
Bridge
Configures the interval of sending LLDP message. The
unit is second. (default: 30)
lldp msg txhold <2-10>
Configures the periodic times of LLDP message.
(default: 4)
7.2.6 Reinitiating Delay
To configure the interval time of enabling LLDP frame after configuring LLDP operation
type, use the following command.
Command
Mode
Description
lldp reinitdelay <1-10>
Bridge
Configures the interval time of enabling LLDP frame
from the time of configuring not to process LLDP
frame. (default: 2)