Dasan V5808 - Source Port of Statistical Data; Subject of RMON History; Number of Sample Data; Interval of Sample Inquiry

User Manual UMN:CLI
V5808
161
write Write running configuration to memory or terminal
SWITCH(config-rmonhistory[5])#
7.3.1.1 Source Port of Statistical Data
To specify a source port of statistical data, use the following command.
Command
Mode
Description
data-source NAME
RMON
Specifies a data object ID:
NAME: enters a data object ID. (ex. ifindex.n1/port1)
7.3.1.2 Subject of RMON History
To identify a subject using RMON history, use the following command.
Command
Mode
Description
owner NAME
RMON
Identifies subject using relevant data, enter the name
(max. 32 characters).
7.3.1.3 Number of Sample Data
To configure the number of sample data of RMON history, use the following command.
Command
Mode
Description
requested-buckets <1-65535>
RMON
Defines a bucket count for the interval, enter the
number of buckets.
1-65535: bucket number (default: 50)
7.3.1.4 Interval of Sample Inquiry
To configure the interval of sample inquiry in terms of second, use the following command.
Command
Mode
Description
interval <1-3600>
RMON
Defines the time interval for the history (in seconds),
enter the value. (default: 1800)
1 sec is the minimum time which can be selected. But the minimum sampling interval
currently is 30 sec, i.e., all intervals will be round up to a multiple of 30 seconds.
7.3.1.5 Activating RMON History
To activate RMON history, use the following command.
Command
Mode
Description
active
RMON
Activates RMON history.
i