UMN:CLI User Manual
V5808
766
To specify the maximum retry time for MGC transactions, use the following command.
mgc max-retry-time <0-65534>
Configures the maximum retry time for MGC
transactions.
0-65534: maximum retry time (unit: second)
Deletes the configured maximum retry time.
To specify the maximum number of times that a message is retransmitted to the MGC,
use the following command.
mgc max-retry-attempts <0-
65534>
Configures the maximum number of times that a
message is retransmitted to the MGC.
0-65534: maximum number of times
no mgc max-retry-attempts
Deletes the configured maximum number of times.
To specify the service status delay time for changes in line service status, use the
following command.
mgc service-change-delay <0-
65534>
Configures the service status delay time for changes in
line service status.
0-65534: service status delay time
no mgc service-change-delay
Deletes the configured delay time.
To specify the gateway softswitch name, use the following command.
Specifies the gateway softswitch name.
NAME: gateway softswitch (format: four ASCII coded
alphabetic characters [A-Z])
Deletes the gateway softswitch name configuration.
12.7.4 Saving VoIP Profile
After configuring a VoIP profile, you need to save the profile with the following command.
Saves a VoIP profile configuration.
Whenever you modify a VoIP profile, you should apply the changes again using the apply
command. If not, the changes will not be applied.
To Next Page
Loading...