Dasan V5808 - Interface Description

User Manual UMN:CLI
V5808
77
ip route default {GATEWAY |
null} [<1-255>]
Global
Configures a default gateway.
To delete a configure default gateway, use the following command.
Command
Mode
Description
no ip route default {GATEWAY |
null} [<1-255>]
Global
Deletes a default gateway.
To display a configured static route, use the following command.
Command
Mode
Description
show ip route [database]
Enable
Global
Bridge
Shows all IP routing table
show ip route [bgp | connected |
kernel | ospf | rip | static |
A.B.C.D | A.B.C.D/M | summary]
Shows configured routing information.
show ip route database [bgp |
connected | kernel | ospf | rip |
static]
Shows configured routing information with IP routing
table database.
To clear IPv4 stale kernel routes form FIB, use the following command.
Command
Mode
Description
clear ip route [kernel]
Enable
Global
Bridge
Clears IPv4 stale routes.
4.3.4 Interface Description
To specify a description on an interface, use the following command.
Command
Mode
Description
description LINE
Interface
Specifies a description on an interface.
LINE: 80-character text that describes the interface.
no description
Deletes a specified description.
The following is the example of specifying a description on the interface 1.
SWITCH(config)# interface 1
SWITCH(config-if)# description sample_description
SWITCH(config-if)# show interface 1
Interface default
Hardware is Ethernet, address is 00d0.cb00.0d83
Description: sample_description
index 43 metric 1 mtu 1500 <UP,BROADCAST,RUNNING,MULTICAST>
VRF Binding: Not bound
Bandwidth 100m